EasyManua.ls Logo

Alcatel-Lucent OmniSwitch 6250 - Ipv6 Multicast Unsolicited-Report-Interval

Alcatel-Lucent OmniSwitch 6250
2018 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-55
ipv6 multicast unsolicited-report-interval
Sets the MLD unsolicited report interval on the specified VLAN or on the system if no VLAN is speci-
fied.
ipv6 multicast [vlan vid] unsolicited-report-interval [seconds]
Syntax Definitions
vid VLAN on which to apply the configuration.
seconds MLD unsolicited report interval in seconds. Valid range is 1 to 65535,
where 0 represents the default setting.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
IPv6 Multicast Switching and Routing must be enabled to set the MLD unsolicited report interval to
use on the system and/or the specified VLANs.
If the MLD unsolicited report interval is already configured on the system, then the VLAN configura-
tion will override the system's configuration.
The unsolicited report interval refers to the time period to proxy any changed MLD membership state.
To restore the MLD unsolicited interval to its default (i.e., 1 second) value on the system if no VLAN
is specified, use ipv6 multicast unsolicited-report-interval followed by the value 0 (e.g., ipv6 multi-
cast unsolicited-report-interval 0) or use only ipv6 multicast unsolicited-report-interval (e.g., ipv6
multicast unsolicited-report-interval).
To restore the MLD unsolicited report interval to its default (i.e., 1 second) value on the specified
VLAN, use ipv6 multicast vlan vid unsolicited-report-interval followed by the value 0 (e.g., ipv6
multicast vlan 2 unsolicited-report-interval 0) or use only
ipv6 multicast vlan vid unsolicited-report-interval (e.g., ipv6 multicast vlan 2 unsolicited-report-
interval).
Examples
-> ipv6 multicast unsolicited-report-interval 20000
-> ipv6 multicast unsolicited-report-interval 0
-> ipv6 multicast unsolicited-report-interval
-> ipv6 multicast vlan 2 unsolicited-report-interval 20000
-> ipv6 multicast vlan 2 unsolicited-report-interval 0
-> ipv6 multicast vlan 2 unsolicited-report-interval
parameter default
seconds 1

Table of Contents

Other manuals for Alcatel-Lucent OmniSwitch 6250

Related product manuals