IP Commands
page 29-112 OmniSwitch 6250 CLI Reference Guide November 2009
show udp statistics
Displays UDP errors and statistics.
show udp statistics
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command displays cumulative statistics since the last time the switch was powered on or since the
last reset of the switch.
Examples
-> show udp statistics
Total datagrams received = 214937,
Error datagrams received = 0,
No port datagrams received = 32891,
Total datagrams sent = 211884
Release History
Release 6.6.1; command was introduced.
Related Commands
output definitions
Total datagrams received Total number of UDP datagrams delivered to UDP applications.
Error datagrams received Number of UDP datagrams that could not be delivered for any reason.
No port datagrams received Number of UDP datagrams that could not be delivered for reasons
other than lack of application at the destination.
Total datagrams sent Total number of UDP datagrams sent from this switch.
show udp ports Displays the UDP Listener table.
To Next Page
Loading...
