Ethernet OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 25-21
ethoam endpoint ccm
Configures the MEP to generate Continuity Check Messages (CCM).
ethoam endpoint mep_id domain {domain_name | mac_address} association association_name
ccm {enable | disable}
Syntax Definitions
mep_id Specifies the Maintenance Association End Point. The valid range is
1–8191.
domain_name Specifies the domain name. For more information on the different
formats of the domain name, refer to ethoam domain command on
page 25-3.
mac_address Specifies the CFM system MAC address.
association_name Name of the Ethernet OAM association. Up to 48 (minus the domain
name length) characters may be used.
enable Enables MEP to generate CCM
s.
disable Disables MEP to generate CCMs.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
The mep_id should be unique amid all those used by or available to the service provider in the specified
MA.
Examples
-> ethoam endpoint 100 domain esd.alcatel-lucent.com association alcatel-sales ccm
enable
Release History
Release 6.6.1; command was introduced.
Related Commands
show ethoam domain
association end-point
Displays the information of a specific MEP in a Management
Domain configured on the bridge.
To Next Page
Loading...
