Link Aggregation Commands
page 12-30 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg partner admin state
Configures the system administrative state of the slot and port for the dynamic aggregate group on the
remote switch. The state values correspond to bits in the actor state octet in the LACPDU frame.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin state
{[active] [timeout] [aggregate] [synchronize] [collect] [distribute] [default] [expire] | none}
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin state
{[[no] active] [[no] timeout] [[no] aggregate] [[no] synchronize] [[no] collect] [[no] distribute]
[[no] default] [[no] expire] | none}
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
active Specifies that bit 0 in the partner state octet is enabled. When this bit is
set, the dynamic aggregate group is able to exchange LACPDU frames.
By default, this value is set.
timeout Specifies that bit 1 in the partner state octet is enabled. When this bit is
set, a short timeout is used for LACPDU frames. When this bit is
disabled, a long timeout is used for LACPDU frames. By default, this
value is set.
aggregate Specifies that bit 2 in the partner state octet is enabled. When this bit is
set, the system considers this port to be a potential candidate for aggre-
gation. If this bit is not enabled, the system considers the port to be indi-
vidual (it can only operate as a single link). By default, this value is set.
synchronize Specifies that bit 3 in the partner state octet is enabled. When this bit is
set, the port is allocated to the correct dynamic aggregation group. If this
bit is not enabled, the port is not allocated to the correct aggregation
group. By default, this value is disabled.
collect Specifying this keyword has no effect because the system always deter-
mines its value. When this bit (bit 4) is set by the system, incoming
LACPDU frames are collected from the individual ports that make up
the dynamic aggregate group.
distribute Specifying that this keyword has no effect because the system always
determines its value. When this bit (bit 5) is set by the system, distribut-
ing outgoing frames on the port is disabled.
default Specifying that this keyword has no effect because the system always
determines its value. When this bit (bit 6) is set by the system, it indi-
To Next Page
Loading...
