RIP Commands
page 33-2 OmniSwitch 6250 CLI Reference Guide November 2009
ip load rip
Loads RIP into memory. When the switch is initially configured, you must load RIP into memory before it
can be enabled.
ip load rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• In simple networks where only IP forwarding is required, you may not want to use RIP. If you are not
using RIP, it is best not to load it to save switch resources.
• To remove RIP from switch memory, you must manually edit the boot.cfg file. The boot.cfg file is an
ASCII text-based file that controls many of the switch parameters. Open the file and delete all refer-
ences to RIP. You must reboot the switch when this is complete.
• Use the ip rip status command to enable RIP on the switch.
Examples
-> ip load rip
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDrcTmConfig
alaDrcTmIPRipStatus
ip rip status Enables/disables RIP routing on the switch.
show ip rip Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
To Next Page
Loading...
