Link Aggregation Commands
page 12-12 OmniSwitch 6250 CLI Reference Guide November 2009
lacp linkagg admin state
Configures the administrative state of the dynamic aggregate (whether it is up and active, or down and
inactive) group.
lacp linkagg agg_num admin state {enable | disable}
Syntax Definitions
agg_num The number corresponding to the dynamic aggregate group.
enable Specifies that the dynamic aggregate group is active and is able to
aggregate links.
disable Specifies that the operation of a dynamic aggregate group cannot be
performed.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
When the administrative state is set to disable, the operation of a dynamic aggregation (LACP) group
cannot be performed.
Examples
-> lacp linkagg 2 admin state disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable enable
To Next Page
Loading...
