RIP Commands
page 33-30 OmniSwitch 6250 CLI Reference Guide November 2009
show ip rip peer
Displays active RIP neighbors (peers). An active peer is a switch that has sent a RIP packet within the last
180 seconds. If a peer does not send a RIP packet (request or response) within 180 seconds, it is aged out
and will not be displayed.
show ip rip peer [ip_address]
Syntax Definitions
ip_address 32-bit IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show ip rip peer
Total Bad Bad xxxxxxxxxxxxSecs since
IP Address Recvd Packets Routes Version last update
----------------+------+-------+------+-------+-----------
100.10.10.1 1 0 0 2 3
Release History
Release 6.6.1; command was introduced.
output definitions
IP Address Peer IP address.
Total recvd Total number of RIP packets received from the peer.
Bad Packets Number of bad packets received from peer.
Bad Routes Number of bad routes received from peer.
Version Peer's RIP version as seen on the last packet received.
Secs since last update Number of seconds since the last packet was received from the peer.
To Next Page
Loading...
