File Management Commands
page 7-42 OmniSwitch 6250 CLI Reference Guide November 2009
more
Displays a switch text file onto the console screen.
more [path/]file
Syntax Definitions
path The directory path leading to the file to be displayed. If no path is speci-
fied, the command assumes the current path.
file The name of the text file to be displayed.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command displays the specified text file within the line and column parameters set with the tty
command.
• If the specified text file contains more columns than set with the tty command, the text will wrap to the
next line displayed.
• If the text file contains more lines than set with the tty command, the switch will display only the
number of lines specified. To display more lines, press the spacebar to show another full screen, press
Enter to show the next line, or press q to quit the display and return to the system prompt.
• This command can also be used on the secondary CMM.
Examples
-> more config_file1
-> more flash/config_file1
-> more flash/working/config_file1
Release History
Release 6.6.1; command was introduced.
Related Commands
tty Specifies the number of TTY lines and columns to be displayed.
To Next Page
Loading...
