802.1Q Commands
page 15-4 OmniSwitch 6250 CLI Reference Guide November 2009
vlan 802.1q frame type
Configures a port to accept all frames or accept only VLAN-tagged frames.
vlan 802.1q slot/port frame type {all | tagged}
Syntax Definitions
slot The slot number to configure 802.1Q tagging.
port The port number to configure 802.1Q tagging.
all Configures this port to accept all frames.
tagged Configures this port to accept only VLAN-tagged frames.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you configure a port to accept only VLAN-tagged frames, then any frames received on this port that do
not carry a VLAN ID (i.e., untagged frames or priority-tagged frames) will be discarded by the ingress
rules for this port. Frames that are not discarded by this ingress rule are classified and processed according
to the ingress rules for this port.
Examples
-> vlan 802.1q 3/1 frame type all
Release History
Release 6.6.1; command was introduced.
parameter default
all | tagged all
To Next Page
Loading...
