QoS Policy Commands
OmniSwitch CLI Reference Guide November 2009 page 39-13
policy service group
Configures a service group and its associated services. The group may be used as part of a policy condi-
tion. The action associated with any policy using the condition will be applied to all members of the
service group.
policy service group service_group service_name1 [service_name2...]
no policy service group service_group
policy service group service_group no service_name1 [service_name2...]
Syntax Definitions
service_group The name of the service group (up to 31 alphanumeric characters).
service_name1 The service name is configured through the policy service command
and includes information about protocol, source port, and destination
port.
service_name2... Optional. Additional service names may be configured for a service
group. Separate each service name with a space.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use this command to configure a group of services to which you want to apply QoS rules. Rather than
create a condition for each service, group services together. Use the policy condition command to
associate a condition with the service group.
• Use the no form of the command to remove a service group from the configuration, or to remove a
service from a service group.
• To drop packets destined to specific TCP and UDP ports, create port services for the traffic that you
want dropped and add these services to a service group called DropServices. Then create a condition
for this service group and a source port group, which can then be used in a deny rule. Refer to the
OmniSwitch 6250 Network Configuration Guide for more information about ACL security enhance-
ments.
• If the snapshot command is entered after the policy service group command is configured, the result-
ing ASCII file will include the following additional syntax for the policy service group command:
from {cli | ldap | blt}
This syntax indicates how the service group was created. The cli and ldap options may be changed by
a user modifying the ASCII file; however, changing this setting is not recommended. The blt option
indicates a built-in service group, this setting is not configurable.
To Next Page
Loading...
