File Management Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 7-39
tty
Specifies the number of lines and columns to be displayed on the terminal screen while the switch is in the
edit file mode.
tty lines columns
Syntax Definitions
lines The number of lines to be displayed on the terminal emulation screen
for the current session. Values may range from 10 to 150.
columns The number of columns to be displayed for each line. One column is the
same width as a single text character. Values may range from 20 to 150.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The number of lines and columns set with this command control the screen size when the switch is
editing or viewing a text file with the vi or more commands.
• The values set with this command do not control the CLI screen when the switch is operating in normal
mode.
• This command can also be used on the secondary CMM.
Examples
-> tty 10 60
Release History
Release 6.6.1; command was introduced.
parameter default
lines 24
columns 80
To Next Page
Loading...
