Learned Port Security Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 19-17
port-security release
Releases a port that was shut down due to a Learned Port Security (LPS) violation. The specified port
resumes normal operation without having to manually reset the port and/or the entire module.
port-security slot/port release
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3). Use a hyphen to specify a
range of ports on the same module (e.g. 3/1-16).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command restores the port to the same operational state it was in before the shutdown. This
includes the activation of any existing LPS configuration for the port.
• Note that when this command is used, all MAC addresses known to the specified port are flushed from
the switch MAC address table.
Examples
-> port-security 2/14 release
-> port-security 4/10-15 release
Release History
Release 6.6.1; command was introduced.
Related Commands
port-security Enables or disables Learned Port Security (LPS) on the switch port(s).
port-security mac Configures a single authorized source MAC address for a port that
belongs to a specified VLAN.
port-security mac-range Configures a list of authorized MAC addresses by defining a range of
addresses allowed on the port.
port-security shutdown Configures the amount of time in minutes to allow source learning on all
LPS ports. Also, enables or disables the conversion of dynamic MAC
addresses to static MAC addresses on LPS ports.
port-security maximum Specifies the maximum number of source MAC addresses that an LPS
port(s) is allowed to learn.
To Next Page
Loading...
