Ethernet Port Commands
page 20-92 OmniSwitch 6250 CLI Reference Guide November 2009
show interfaces hybrid flood rate
Displays interface peak flood rate settings for combo ports.
show interfaces [slot[/port[-port2]]] hybrid {fiber |copper} flood rate
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
fiber Specifies that the status of the SFP port(s) will be displayed.
copper Specifies that the status of the copper RJ-45 port(s) will be displayed.
Defaults
If a specific slot or slot/port number is not entered with this command, the peak rate settings for all switch
combo ports is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Enter a slot and port number or a range of port numbers to display information for a specific combo
port or a range of combo ports.
• Enter a slot number to display information for all combo ports on a specific slot.
Examples
-> show interfaces flood rate
Slot/Port peak rate(Mb/second) Enable
-----------+----------------------+---------------
02/01 12 Flood only
02/02 47 Flood only
02/03 16 Flood only
02/04 47 Flood only
02/05 47 Flood only
02/06 47 Flood only
02/07 47 Flood only
02/08 47 Flood only
02/09 47 Flood only
02/10 47 Flood only
02/11 47 Flood only
02/12 47 Flood only
02/13 47 Flood only
02/14 47 Flood only
02/15 47 Flood only
02/16 47 Flood only
To Next Page
Loading...
