Alcatel-Lucent OmniSwitch 6250 - Ip Multicast Querier-Forwarding

IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-5
ip multicast querier-forwarding
Enables or disables IGMP querier forwarding on the specified VLAN or on the system if no VLAN is
specified.
ip multicast [vlan vid] querier-forwarding [{enable | disable}]
no ip multicast [vlan vid] querier-forwarding
Syntax Definitions
vid The VLAN on which configuration is applied.
enable Enable IGMP querier forwarding.
disable Disable IGMP querier forwarding.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove an IGMP querier forwarding entry on the specified VLAN
or on the system and return to its default behavior.
• If the IGMP querier forwarding is already enabled on the system, then the VLAN configuration will
override the system's configuration.
• IGMP querier forwarding refers to promoting detected IGMP queriers to receive all IP multicast data
traffic.
Examples
-> ip multicast querier-forwarding enable
-> ip multicast querier-forwarding disable
-> ip multicast querier-forwarding
-> ip multicast vlan 2 querier-forwarding enable
-> ip multicast vlan 2 querier-forwarding disable
-> ip multicast vlan 2 querier-forwarding
-> no ip multicast vlan 2 querier-forwarding
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable