SNMP Commands
page 10-30 OmniSwitch 6250 CLI Reference Guide November 2009
show snmp trap config
Displays SNMP trap information. Information includes trap ID numbers, trap names, command families,
and absorption rate. This command also displays the Enabled/Disabled status of SNMP absorption and the
Traps to WebView service.
show snmp trap config
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
N/A
Examples
-> show snmp trap config
Absorption service : enabled
Traps to WebView : enabled
Id trapName family absorption
--+------------------------------------+---------------+------------
0 coldStart chassis 15 seconds
1 warmStart chassis 15 seconds
2 linkDown interface 15 seconds
3 linkUp interface 15 seconds
4 authenticationFailure snmp 15 seconds
5 entConfigChange module 15 seconds
30 slPesudoCAMStatusTrap bridge 15 seconds
34 ifMauJabberTrap interface 15 seconds
35 sessionAuthenticationTrap session 15 seconds
---------------------------------------------------------------------
Release History
Release 6.6.1; command was introduced.
output definitions
Id Identification number for the trap.
Trap Name Name of the trap.
Family Family to which the trap belongs.
Absorption Time needed for the trap to process.
To Next Page
Loading...
