Source Learning Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 18-19
show source-learning
Displays the source learning status of a port or link aggregate of ports.
show source-learning [port slot/port[-port2] | linkagg linkagg_num]
Syntax Definitions
slot/port1 The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
-port2 The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1, 2, 3, and 4 on slot 3).
linkagg_num Specifies the link aggregate identifier.
Defaults
By default, the source learning status for all switch ports and link aggregates is displayed.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the port slot/port or linkagg linkagg_num parameters to display the source learning status for a
specific port or link aggregate ID.
• When the source learning status is configured for a link aggregate ID, it affects all the ports that are
members of the link aggregate. However, source learning status cannot be configured on individual
ports which are members of the link aggregate.
Example
-> show source-learning
port source-learning
-----+-------------
1/1 disabled
1/2 enabled
1/3 disabled
-> show source-learning port 1/2
port source-learning
-----+-------------
1/2 disabled
-> show source-learning linkagg 10
port source-learning
-----+-------------
0/10 disabled
To Next Page
Loading...
