VLAN Management Commands
page 22-2 OmniSwitch 6250 CLI Reference Guide November 2009
vlan
Creates a new VLAN with the specified VLAN ID (VID) and an optional description.
vlan vid [enable | disable] [name description]
no vlan vid
Syntax Definitions
vid A numeric value (2–4094) that uniquely identifies an individual VLAN.
This value becomes the VLAN ID for the new VLAN.
description Text string up to 32 characters. Use quotes around string if description
contains multiple words with spaces between them (e.g. “Alcatel-Lucent
Marketing VLAN”).
enable Enable VLAN administrative status.
disable Disable VLAN administrative status.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to delete a VLAN from the configuration. All VLAN ports and rout-
ers are detached before the VLAN is removed. Ports return to their default VLANs or VLAN 1, if the
VLAN deleted is the port’s configured default VLAN.
• Note that specifying multiple VLAN IDs and/or a range of VLAN IDs on the same command line is
allowed. Use a hyphen to indicate a contiguous range and a space to separate multiple VLAN ID
entries (e.g., vlan 10-15 500-510 850).
• A VLAN is not operationally active until at least one active port is assigned to the VLAN.
• When a VLAN is administratively disabled, static port and dynamic mobile port assignments are
retained but traffic on these ports is not forwarded. However, VLAN rules remain active and continue
to classify mobile port traffic for VLAN membership.
• Ports are manually configured or dynamically assigned to VLANs.
parameter default
enable | disable enable
description VLAN ID
To Next Page
Loading...
