IP Multicast Switching Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 41-53
ipv6 multicast query-response-interval
Sets the MLD query response interval on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] query-response-interval [milliseconds]
Syntax Definitions
vid VLAN on which to apply the configuration.
milliseconds MLD query response interval in milliseconds. Valid range is 1 to 65535.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• IPv6 Multicast Switching and Routing must be enabled to set the MLD query response interval to use
on the system and/or the specified VLANs.
• If the MLD query response interval is already configured on the system, then the VLAN configuration
will override the system's configuration.
• The MLD query response interval refers to the time period to reply to an MLD query message.
• To restore the MLD query response interval to its default (i.e., 10000 milliseconds) value on the
system if no VLAN is specified, use ipv6 multicast query-response-interval followed by the value 0
(e.g., ipv6 multicast query-response-interval 0) or use only ipv6 multicast query-response-interval
(e.g., ipv6 multicast query-response-interval).
• To restore the MLD last member query interval to its default (i.e., 10000 milliseconds) value on the
specified VLAN, use ipv6 multicast vlan vid query-response-interval followed by the value 0 (e.g.,
ipv6 multicast vlan 2 query-response-interval 0) or use only
ipv6 multicast vlan vid query-response-interval (e.g., ipv6 multicast vlan 2 query-response-interval).
Examples
-> ipv6 multicast query-response-interval 20000
-> ipv6 multicast query-response-interval 0
-> ipv6 multicast query-response-interval
-> ipv6 multicast vlan 2 query-response-interval 20000
-> ipv6 multicast vlan 2 query-response-interval 0
-> ipv6 multicast vlan 2 query-response-interval
Release History
Release 6.6.1; command was introduced.
parameter default
milliseconds 10000
To Next Page
Loading...
