IP Commands
page 29-32 OmniSwitch 6250 CLI Reference Guide November 2009
ip route-map match ip-nexthop
Matches any routes that have a next-hop router address permitted by the specified access list name or the
IP address specified in the route map.
ip route-map route-map-name [sequence-number number] match ip-nexthop
{access-list-name | ip_address/prefixLen [permit | deny]}
no ip route-map route-map-name [sequence-number number] match ip-nexthop
{access-list-name | ip_address/prefixLen [permit | deny]}
Syntax Definitions
route-map-name The name of the route map (up to 20 characters).
number A number that links together the route maps. The range is 1–100.
access-list-name The access list that matches the route nexthop IP address.
ip_address/prefixLen The IP address along with the prefix length that matches any nexthop IP
address within the specified subnet.
permit Permits a route based on the IP nexthop.
deny Denies a route based on the IP nexthop.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to delete the match ip-nexthop parameter in the route map.
• If the best matching nexthop is type deny, then the route is not redistributed. If the best matching
nexthop is type permit and the route map action is deny, the route is not redistributed.
• All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
• The route-map-name, sequence-number, and access-list-name should exist before you configure this
match criteria.
parameter default
number 50
permit | deny permit
To Next Page
Loading...
