Interswitch Protocol Commands
page 14-2 OmniSwitch 6250 CLI Reference Guide November 2009
amap
Enables or disables the Alcatel-Lucent Mapping Adjacency Protocol (AMAP) on the switch. AMAP
discovers adjacent switches by sending and responding to Hello update packets on active Spanning Tree
ports.
amap {enable | disable}
Syntax Definitions
enable Enables AMAP.
disable Disables AMAP.
Defaults
By default, AMAP is enabled on the switch.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Adjacent switches are defined as those having a Spanning Tree path between them and no other switch
between them on the same Spanning Tree path that has AMAP enabled.
Examples
-> amap disable
-> amap enable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
aipAMAPstate
amap discovery time Sets the discovery transmission time interval used by active Span-
ning Tree ports in the discovery transmission state.
amap common time Sets the common transmission time interval used by active Span-
ning Tree ports in the common transmission state.
show amap Displays adjacent switches and associated MAC addresses, ports,
VLANs, and IP addresses.
To Next Page
Loading...
