Alcatel-Lucent OmniSwitch 6250 - OmniSwitch 6250-24 M;24-MD Front Panel

CMM Commands
page 1-8 OmniSwitch 6250 CLI Reference Guide November 2009
write memory
Copies the running configuration (RAM) to the working directory.
[configure] write memory
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is used to copy the changes made using the CLI commands from the running configura-
tion (RAM) to the working directory.
• This command is only valid if the switch is running from the working directory. Use the show
running-directory command to check from where the switch is running.
• This command performs the same function as the copy running-config working command.
Note. The saved boot.cfg file will be overwritten if the takeover command is executed after the copy
running-config working or write memory commands, in an OmniSwitch set up with redundant CMMs.
Examples
-> configure write memory
-> write memory
Release History
Release 6.6.1; command was introduced.
Related Commands
copy running-config working Copies the running primary RAM version of the CMM software to the
working primary flash. Or copy the startup primary flash version of the
CMM software to the working primary flash.
copy flash-synchro Copies the startup primary flash version of the CMM software to the
startup secondary flash version of the CMM software.