802.1AB Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 13-17
lldp tlv med
Specifies the switch to control per port LLDP-MED (Media Endpoint Device) TLVs to be incorporated in
the LLDPDUs.
lldp {slot/port | slot | chassis} tlv med {power | capability} {enable | disable}
Syntax Definitions
slot/port Slot number for the module and physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
slot The slot number for a specific module.
power Enables or disables transmission of LLDP-MED extended POE TLV in
LLDPDU.
capability Enables or disables transmission of LLDP-MED capabilities TLV in
LLDPDU.
enable Enables LLDP-MED TLV LLDPDU transmission.
disable Disables LLDP-MED TLV LLDPDU transmission.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The LLDPDU must be enabled and set to transmit before using this command.
• If this command is applied to a slot or chassis, then the existing configuration related to this command
will be lost.
• The lldp tlv med power version of this command applies only to PoE units.
• Before enabling the Power MED TLV, use the lanpower start command to activate PoE on a port or
on all ports in a specific slot.
Examples
-> lldp 4/4 tlv med power enable
-> lldp 4/3 tlv med capability enable
-> lldp 4 tlv med power disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
