LINK OAM Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 26-3
efm-oam
Enables or disables the LINK OAM protocol on the switch.
efm-oam {enable | disable}
Syntax Definitions
enable Enables the LINK OAM protocol.
disable Disables the LINK OAM protocol.
Defaults
By default, the LINK OAM protocol is disabled for the switch.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• LINK OAM must be enabled globally for the OAM to be functional on all the ports.
• When LINK OAM is disabled globally, all dynamically learned information on the port, including peer
information, is deleted. However, the LINK OAM configuration for the port is retained.
Examples
-> efm-oam enable
-> efm-oam disable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaDot3OamStatus
efm-oam port status Enables or disables LINK OAM protocol on the specified port or on
a range of ports.
efm-oam port mode Configures the LINK OAM mode on the port or on the range of
ports to active or passive.
show efm-oam configuration Displays the global LINK OAM configuration.
To Next Page
Loading...
