Alcatel-Lucent OmniSwitch 6250 - Primary Management Module Selection; Using the Chassis MAC Address

Power over Ethernet (PoE) Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 4-5
lanpower power
Specifies the maximum amount of inline power, in milliwatts, allocated to a specific PoE port. The value
specified is used to supply inline power to devices such as IP telephones and wireless LAN devices.
lanpower {slot/port | slot} power milliwatts
Syntax Definitions
slot/port A PoE port on which the maximum amount of inline power is being
allocated.
milliwatts The maximum amount of inline power, in milliwatts, being allocated to
the corresponding port (3000–16000 or 3000-31000).
Defaults
Platforms Supported
OmniSwitch 6250-Enterprise Models
Usage Guidelines
• To globally specify the amount of inline power allocated to all ports in a slot, refer to the lanpower
maxpower command on page 4-7.
• Be sure that the value specified complies with specific power requirements for all attached IP tele-
phones and wireless LAN devices.
• Note that the power value for the lanpower power command is specified in milliwatts (mW); the
related command, lanpower maxpower, is specified in watts (W).
Examples
-> lanpower 3/1 power 3025
Release History
Release 6.6.1; command was introduced.
parameter default
milliwatts (802.3af ports)
milliwatts (802.3at ports)
16000
31000