Alcatel-Lucent OmniSwitch 6250 - OmniSwitch 6250-24

CMM Commands
page 1-12 OmniSwitch 6250 CLI Reference Guide November 2009
copy flash-synchro
Copies the certified directory version of the primary CMM software to the certified directory of the
secondary CMM.
[configure] copy flash-synchro
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• This command is used to synchronize the certified directories of the primary and secondary CMMs.
The two CMMs must be in synchronization if a fail over occurs, otherwise switch performance is lost.
• If the switch is part of stackable configuration, all switches in the stack are updated with the primary
CMM files.
Examples
-> copy flash-synchro
-> configure copy flash-synchro
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
chasControlModuleTable
csEntPhysicalIndex
chasControlVersionMngt
copy working certified Copies the running primary RAM version of the CMM software to the
working primary flash. Or copies the startup primary flash version of
the CMM software to the working primary flash.
copy working certified Copies the working primary flash version of the CMM software to cer-
tified primary flash. Or copies the working primary flash version of the
CMM software to startup secondary flash.