Switch Logging Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 45-13
show swlog
Displays switch logging information (e.g., switch logging status, log devices, application IDs with non-
default severity level settings).
show swlog
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This command can also be used on the secondary CMM.
Examples
-> show swlog
Switch Logging is :
- INITIALIZED.
- RUNNING.
Log Device(s)
-------------
flash
console
socket ipaddr 11.1.1.1
socket ipaddr 12.1.1.1
socket ipaddr 13.1.1.1
socket ipaddr 14.1.1.1
All Applications have their trace level set to the level 'info' (6)
Release History
Release 6.6.1; command was introduced.
output definitions
Application ID The Application ID (subsystem) for which the Severity Level is not set
to the info (6) default setting.
Level The Severity Level of the above-referenced Application ID. Levels
include (2), error (3), alert (4), warning (5), info (6), debug1 (7),
debug2 (8), and debug3 (9).
To Next Page
Loading...
