Alcatel-Lucent OmniSwitch 6250 - Show Ip Rip Routes

RIP Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 33-25
show ip rip routes
Displays the RIP routing database. The routing database contains all of the routes learned through RIP.
show ip rip routes [ip_address ip_mask]
Syntax Definitions
ip_address 32-bit IP address.
ip_mask The mask corresponding to the IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
To view all RIP routes, enter the basic command syntax (show ip rip routes). To view a specific route,
enter the destination IP address and mask.
Examples
-> show ip rip routes
Legends: State: A = Active, H = Holddown, G = Garbage
Destination Gateway State Metric Proto
------------------+-----------------+----+------+------
2.0.0.0/8 +5.0.0.14 A 2 Rip
4.0.0.7 A 3 Rip
4.0.0.0/8 +5.0.0.14 A 3 Rip
2.0.0.14 A 3 Rip
5.0.0.0/8 +2.0.0.14 A 2 Rip
4.0.0.7 A 3 Rip
10.0.0.0/8 +4.0.0.7 A 2 Rip
5.0.0.14 A 2 Rip
2.0.0.14 A 2 Rip
22.0.0.0/8 +5.0.0.14 A 2 Rip
2.0.0.14 A 2 Rip
4.0.0.7 A 3 Rip
128.251.40.0/24 +4.0.0.7 A 2 Rip
5.0.0.14 A 3 Rip
2.0.0.14 A 3 Rip
150.0.0.0/24 +4.0.0.7 A 2 Rip
5.0.0.14 A 2 Rip
2.0.0.14 A 2 Rip
152.0.0.0/24 +4.0.0.7 A 2 Rip
5.0.0.14 A 3 Rip