QoS Commands
OmniSwitch CLI Reference Guide November 2009 page 38-33
qos reset
Resets the QoS configuration to its defaults.
qos reset
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use this command to reset QoS configuration that has not yet been applied through the qos apply
command. The parameters are reset to their defaults.
Examples
-> qos reset
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaQoSConfigTable
alaQoSConfigReset
qos apply Applies all QoS settings configured on the switch to the current configu-
ration.
qos revert Deletes any QoS configuration that has not been applied to the configu-
ration through the qos apply command.
To Next Page
Loading...
