Power over Ethernet (PoE) Commands
page 4-4 OmniSwitch 6250 CLI Reference Guide November 2009
lanpower stop
Manually disables power on a single specified PoE port or on all PoE ports in a specified slot.
lanpower stop {slot/port[-port2] | slot}
Syntax Definitions
slot/port Disables inline power on the specified PoE port only.
port2 The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
slot Disables inline power on all PoE ports in the corresponding slot.
Defaults
Power over Ethernet operational status is globally disabled by default.
Platforms Supported
OmniSwitch 6250-Enterprise Models
Usage Guidelines
N/A
Examples
-> lanpower stop 5/22
-> lanpower stop 5
-> lanpower stop 5/22-27
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaPethMainPseGroup
alaPethMainPseAdminStatus
pethPsePortTable
pethPsePortAdminEnable
lanpower start Activates inline power on a single specified PoE port or on
all PoE ports in a specified slot.
lanpower combo-port Displays current inline power status and related statistics for
all PoE ports in a specified slot.
To Next Page
Loading...
