Chassis Management and Monitoring Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 2-9
system timezone
Displays or modifies the time zone for the switch.
system timezone [timezone_abbrev | offset_value | time_notation]
Syntax Definitions
timezone_abbrev Specifies a time zone for the switch and sets the system clock to run on
UTC. Refer to the table below for a list of supported time zone abbrevi-
ations. If you specify a time zone abbreviation, the hours offset from
UTC will be automatically calculated by the switch.
offset_value Specifies the number of hours offset from UTC. Values may range from
-13 through +12. The switch automatically enables UTC. However, if
you do not want your system clock to run on UTC, simply enter the
offset +0 for the system time zone. This sets UTC to run on local time.
time_notation Specifies a non-integer time-notation offset for areas that are offset from
UTC by increments of 15, 30, or 45 minutes (e.g., 05:30).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• To display the current time zone for the switch, enter the syntax system timezone.
• When Daylight Saving Time (DST)—also referred to as summertime—is enabled, the clock automati-
cally sets up default DST parameters for the local time zone.
• Refer to the table below for a list of supported time zone abbreviations.
Abbreviation Name Hours from
UTC
DST Start DST End DST Change
nzst New Zealand +12:00 1st Sunday in Oct. at
2:00 a.m.
3rd Sunday in Mar.
at 3:00 a.m.
1:00
zp11 No standard name +11:00 No default No default No default
aest Australia East +10:00 Last Sunday in Oct.
at 2:00 a.m.
Last Sunday in Mar.
at 3:00 a.m.
1:00
gst Guam +10:00 No default No default No default
acst Australia Central
Time
+09:30 Last Sunday in Oct.
at 2:00 a.m.
Last Sunday in Mar.
at 3:00 a.m.
1:00
jst Japan +09:00 No default No default No default
kst Korea +09:00 No default No default No default
awst Australia West +08:00 No default No default No default
To Next Page
Loading...
