Link Aggregation Commands
page 12-36 OmniSwitch 6250 CLI Reference Guide November 2009
lacp agg partner admin system priority
Configures the partner system priority for a dynamic aggregate group port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin system priority
partner_admin_system_priority
lacp agg [ethernet | fastethernet | gigaethernet] slot/port
no partner admin system priority
Syntax Definitions
ethernet Documents that the port is 10 Mbps Ethernet.
fastethernet Documents that the port is 100 Mbps Fast Ethernet.
gigaethernet Documents that the port is Gigabit Ethernet.
slot The slot number for this aggregate.
port The port that the switch will initially use as the Spanning Tree virtual
port for this aggregate.
partner_admin_system_priority The priority of the remote switch’s dynamic aggregate group to which
the aggregation group is attached. Possible values are 0–255.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove a partner_system_priority value from a slot and port asso-
ciated with a dynamic aggregate group.
• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See
Chapter 20, “Ethernet Port Commands,” for information on CLI commands to configure Ethernet ports.
Examples
-> lacp agg 2/1 partner admin system priority 65
-> lacp agg 2/1 no partner admin system priority
Release History
Release 6.6.1; command was introduced.
parameter default
partner_admin_system_priority 0
To Next Page
Loading...
