Port Mirroring and Monitoring Commands
page 34-2 OmniSwitch 6250 CLI Reference Guide November 2009
port mirroring source destination
Defines a port to mirror and the port that is to receive data from the mirrored port, and enables or disables
port mirroring status. Also, enables or diables remote port mirroring.
port mirroring port_mirror_sessionid [no] source slot/port[-port2] [slot/port[-port2]...]
destination slot/port [rpmir-vlan vlan_id] [bidirectional |inport |outport] [unblocked vlan_id]
[enable | disable]
Syntax Definitions
port_mirror_sessionid Mirroring session identifier.
source Adds the alphabet “a” to a port mirroring session.
no source Removes a port or range of ports from a port mirroring session.
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
[slot/port[-port2]...] Configures multiple source ports.
rpmir-vlan vlan_id Reserved VLAN (1–4094) to carry the mirroring traffic.
bidirectional Specifies bidirectional port mirroring.
inport Specifies incoming unidirectional port mirroring.
outport Specifies outgoing unidirectional port mirroring.
vlan_id VLAN ID is the number (1–4094) that specifies the VLAN to protect
from Spanning Tree changes while port mirroring/monitoring is active.
Ports in this VLAN will remain unblocked.
enable Enables port mirroring status.
disable Disables port mirroring status.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The maximum number of mirroring sessions is limited to two.
parameter default
bidirectional | inport | outport bidirectional
enable | disable enable
To Next Page
Loading...
