Alcatel-Lucent OmniSwitch 6250 - Ipv6 Rip Invalid-Timer

IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-67
ipv6 rip invalid-timer
Configures the amount of time a route remains active in RIB before being moved to the "Garbage" state.
ipv6 rip invalid-timer seconds
Syntax Definitions
seconds Time, in seconds, that a route will remain in an “Active” state. Valid
range is 1 - 300.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
This timer is reset each time a routing update is received.
Examples
-> ipv6 rip invalid-timer 300
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngInvalidTimer
parameter default
seconds 180
ipv6 rip garbage-timer Configures the RIPng garbage timer value.
ipv6 rip holddown-timer Configures the amount of time a route is placed in a holddown state.