Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-47
show interfaces accounting
Displays interface accounting information (e.g., packets received/transmitted and deferred frames
received).
show interfaces [slot[/port[-port2]]] accounting
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no slot/port numbers are entered, accounting information for all slots/ports on the switch is
displayed.
• You can display a specific interface by entering the slot and port number (e.g., 3/1).
• You can display a range of port numbers (e.g., 3/1-4).
• You can display all interfaces in a slot by entering the slot number (e.g., 3).
• For combo ports configured as either forced fiber or preferred fiber the accounting information for the
SFP fiber ports and not the copper RJ-45 ports will be displayed. See the show interfaces hybrid
accounting command for more information.
• For combo ports configured as either forced copper or preferred copper the accounting information for
the copper RJ-45 ports and not the SFP fiber port will be displayed. See the show interfaces hybrid
accounting command for more information.
To Next Page
Loading...
