QoS Policy Commands
page 39-124 OmniSwitch CLI Reference Guide November 2009
policy action 802.1p
Configures a value to be set in the 802.1p bits of the 802.1Q byte of an outgoing frame for traffic that
matches a policy with this action.
policy action action_name 802.1p 802.1p_value
policy action action_name no 802.1p
Syntax Definitions
action_name The name of the action.
802.1p_value The priority value to be set in 802.1Q frames. Values range from 0
(lowest priority) to 7 (highest priority).
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of the command to remove an 802.1p value from a policy action.
• Note that specifying both ToS and DSCP in the same action is not allowed.
• An 802.1p or ToS/DSCP action always sets the packet priority. For 802.1p marking, the priority is set
according to the marked 802.1p. For ToS marking, the priority is set according to the marked ToS. For
DSCP marking, the priority is set according to the marked DSCP.
Examples
-> policy action action4 802.1p 7
-> policy action action4 no 802.1p
Release History
Release 6.6.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
policy action Creates a policy action.
show policy action Displays information about actions configured on the switch.
To Next Page
Loading...
