Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-41
show interfaces capability
Displays default auto negotiation, speed, duplex, flow, and cross-over settings for a single port, a range of
ports, or all ports on a Network Interface (NI) module.
show interfaces [slot[/port[-port2]]] capability
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The show interfaces capability command displays defaults settings in two rows of data for each port.
The first row of data, identified by the label CAP, displays the valid user-defined configuration
settings available for the port. The second row, identified by the label DEF, displays the default
settings for the port.
Examples
-> show interfaces 5/1 capability
Slot/Port AutoNeg Flow Crossover Speed Duplex
-----------+---------+--------+-----------+----------+----------
5/1 CAP EN/DIS EN/DIS MDI/X/Auto 10/100/1G Full/Half
5/1 DEF EN EN Auto Auto Auto
output definitions
Slot The slot number.
Port The port number
AutoNeg In the row labeled CAP, the field displays the valid auto negotiation
configurations for the port. In the row label DEF, the field displays the
default auto negotiation settings for the port. The possible values are
EN (enabled) or DIS (disabled).
Flow In the row labeled CAP, the field displays the valid flow configurations
for the port. In the row label DEF, the field displays the default flow
settings for the port. The possible values are EN (enabled) or DIS (dis-
abled).
To Next Page
Loading...
