802.1X Commands
page 44-26 OmniSwitch 6250 CLI Reference Guide November 2009
show 802.1x
Displays information about ports configured for 802.1X.
show 802.1x [slot/port]
Syntax Definitions
slot The slot of the port for which you want to display information.
port The port for which you want to display 802.1X information.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you do not specify a particular slot/port, information for all 802.1X ports is displayed.
Examples
-> show 802.1x 1/13
802.1x configuration for slot 1 port 13:
direction = both,
operational directions = both,
port-control = auto,
quiet-period (seconds) = 60,
tx-period (seconds) = 30,
supp-timeout (seconds) = 30,
server-timeout (seconds) = 30,
max-req = 2,
re-authperiod (seconds) = 3600,
reauthentication = no
Supplicant polling retry count = 2
output definitions
direction
Whether the port is configured for control on bidirectional traffic or
incoming traffic only. May be configured through the 802.1x com-
mand. Possible values are both or in.
operational directions
The operational state of controlled direction on the port, which is set
automatically by the switch. If the value of direction is both, the value
of operational directions is both. If the value of direction is in, the
operational state is set to in on initialization and when the port’s MAC
address becomes operable. If the port’s MAC address becomes inopera-
ble, the operational direction is set to both.
To Next Page
Loading...
