802.1X Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 44-27
Release History
Release 6.6.1; command was introduced.
Related Commands
port-control
The value of the port control parameter for the port (auto, force-autho-
rized, or force-unauthorized), which is set through the 802.1x com-
mand.
quiet-period
The time during which the port will not accept an 802.1X authentica-
tion attempt; the timer is activated after any authentication failure. The
range is 0 to 65535 seconds.
tx-period
The time before an EAP Request Identity will be transmitted. The range
is 1 to 65535 seconds.
supp-timeout
The number of seconds before the switch will time out an 802.1x user
who is attempting to authenticate.
server-timeout
The timeout for the authentication server for authentication attempts.
This value is always superseded by the value configured for the
RADIUS authentication server configured through the aaa radius-
server command.
max-req
The maximum number of times the switch will retransmit a request for
authentication information (request identity, password, challenge, etc.)
to the 802.1X user before it times out the authentication session based
on the supp-timeout. The range is 1 to 10.
re-authperiod
The amount of time that must expire before the switch requires re-
authentication of the Supplicant on this port. Only applicable when re-
authentication is enabled.
reauthentication
Whether or not the port will be re-authenticated after the re-authperiod
expires.
Supplicant polling retry count The number of times a device is polled for EAP frames to determine
whether or not the device is an 802.1x client. Configured through the
802.1x supp-polling retry command.
802.1x Configures 802.1X parameters on a particular slot/port.
802.1x supp-polling retry Configures the number of times to poll a device for EAP frames to
determine whether or not the device is an 802.1x client.
output definitions (continued)
To Next Page
Loading...
