IP Commands
page 29-24 OmniSwitch 6250 CLI Reference Guide November 2009
ip access-list address
Adds multiple IPv4 addresses to the specified IPv4 access list.
ip access-list access-list-name address address/prefixLen [action {permit | deny}]
[redist-control {all-subnets | no-subnets | aggregate}]
no ip access-list access-list-name address address/prefixLen
Syntax Definitions
access-list-name Name of the access list.
address/prefixLen IP address/prefix length to be added to the access list.
permit Permits the IP address for redistribution.
deny Denies the IP address for redistribution.
all-subnets Redistributes or denies all the subnet routes that match the network
portion of the IP address as specified by the mask length
no-subnets Redistributes or denies only those routes that exactly match the IP
address and the mask length.
aggregate Redistributes an aggregate route if there are one or more routes that
match or are subnets of this address.
Defaults
Usage Guidelines
• Use the no form of this command to delete the address from the access list.
• The access-list-name should exist before you add multiple addresses to it.
• The action parameters (permit and deny) determine if a route that matches the redist-control configu-
ration for the IP address is allowed or denied redistribution.
• The redist-control parameters (all-subnets, no-subnets, and aggregate) defines the criteria used to
determine if a route matches an address in the access list.
• Note that configuring the combination of redist-control aggregate with action deny is not allowed.
• Use this command multiple times with the same access list name to add multiple addresses to the exist-
ing access list.
parameter default
permit | deny permit
all-subnets | no-subnets |
aggregate
all-subnets
To Next Page
Loading...
