Network Time Protocol Commands
page 5-6 OmniSwitch 6250 CLI Reference Guide November 2009
ntp client
Enables or disables NTP operation on the switch.
ntp client {enable | disable}
Syntax Definitions
enable Enables NTP.
disable Disables NTP.
Defaults
NTP protocol is disabled by default.
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use this command to enable or disable NTP. Before NTP can be enabled, an NTP server must be speci-
fied using the ntp server command.
Examples
-> ntp client enable
-> ntp client disable
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
alaNtpEnable
ntp server Specifies an NTP server from which the switch will receive updates.
To Next Page
Loading...
