Learned Port Security Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 19-9
port-security convert-to-static
Converts the dynamically learned MAC addresses on the LPS port(s) to static MAC addresses.
port-security {slot/port[-port2] | chassis} convert-to-static
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
-port2 The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
chassis Specifies all the LPS-eligible ports on the chassis.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• You can stop the aging out of dynamic MAC addresses on the LPS port(s) by converting them to static
MAC addresses.
• The conversion of dynamic MAC addresses to static ones does not apply to LPS mobile and authenti-
cated ports.
• The number of converted static MAC addresses cannot exceed the maximum number of MAC
addresses allowed on the port(s).
Examples
-> port-security 4/8 convert-to-static
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
