UDLD Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 27-3
udld port
Enables or disables UDLD status on a specific port or a range of ports.
udld port slot/port[-port2] {enable | disable}
Syntax Definitions
slot/port The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
port2 The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
enable Enables UDLD status on a port.
disable Disables UDLD status on a port.
Defaults
Platforms Supported
OmniSwitch 6250-Metro Models
Usage Guidelines
The UDLD protocol must be enabled before using this command.
Examples
-> udld port 1/3 enable
-> udld port 1/6-10 enable
-> udld port 2/4 disable
Release History
Release 6.6.1; command was introduced.
parameter default
enable | disable disable
To Next Page
Loading...
