VLAN Stacking Commands
page 24-18 OmniSwitch CLI Reference Guide November 2009
ethernet-service sap-profile
Creates a profile for a VLAN Stacking Service Access Point (SAP). Profile attributes are used to define
traffic engineering policies that are applied to traffic serviced by the SAP.
ethernet-service sap-profile sap-profile-name [bandwidth not-assigned] [[shared | not-shared]
ingress-bandwidth mbps | cir bps [cbs byte] [pir bps] [pbs byte]] [cvlan-tag {preserve | translate}]
priority [map-inner-to-outer-p | map-dscp-to-outer-p | fixed value]
no ethernet-service sap-profile sap-profile-name
Syntax Definitions
sap-profile-name Alphanumeric string of up to 32 characters. Use quotes around string if
the profile name contains multiple words with spaces between them
(e.g., “Alcatel-Lucent Engineering”).
bandwidth not-assigned This parameter is not supported.
shared Shares the ingress bandwidth limit across all SAP ports and CVLANs.
not shared Applies the ingress bandwidth limit to individual SAP ports and
CVLANs; bandwidth is not shared.
ingress bandwidth mbps The maximum amount of bandwidth, in megabits per second, to allow
for SAP ports.
cir bps The committed information rate, in bits per second.
cbs byte The committed burst size value, in bytes.
pir bps The peak information rate, in bits per second.
pbs byte The peak burst size value, in bytes.
preserve Retains the customer VLAN ID (inner tag) and double tags the frame
with the SVLAN ID (outer tag).
translate Replaces the customer VLAN ID with the SVLAN ID.
map-inner-to-outer-p Maps the customer VLAN (inner tag) priority bit value to the SVLAN
(outer tag) priority bit value.
map-dscp-to-outer-p Maps the customer VLAN (inner tag) DSCP value to the SVLAN (outer
tag) priority bit value.
fixed value Sets the SVLAN (outer tag) priority bit to the specified value. Values
range from 0 (lowest priority) to 7 (highest priority).
To Next Page
Loading...
