Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-61
show interfaces ifg
Displays interface inter-frame gap values.
show interfaces [slot[/port[-port2]]] ifg
Syntax Definitions
slot Slot number you want to display.
port Port number of the interface you want to display.
port2 Last port number in a range of ports you want to display.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• If no slot/port numbers are entered, IFG values for all slots/ports on the switch are displayed.
• You can display a specific interface by entering the slot and port number (e.g., 3/1).
• You can display a range of port numbers (e.g., 3/1-4).
• You can display all interfaces in a slot by entering the slot number (e.g., 3).
Examples
-> show interfaces ifg
Slot/Port ifg(Bytes)
-----------+-------------
02/01 12
02/02 12
02/03 12
02/04 12
02/05 12
02/06 12
02/07 12
02/08 12
02/09 12
02/10 12
02/11 12
02/12 12
02/13 12
02/14 12
02/15 12
02/16 12
02/17 12
02/18 12
To Next Page
Loading...
