IP Multicast VLAN Commands
page 42-10 OmniSwitch 6250 CLI Reference Guide November 2009
vlan ipmvlan receiver-port
Configures a port, a range of ports, or an aggregate of ports as receiver ports for the IP Multicast VLAN.
vlan ipmvlan ipmvlan-id receiver-port {port slot/port[-port2] | linkagg agg_num [-agg_num2]}
no vlan ipmvlan ipmvlan-id receiver-port {port slot/port[-port2] | linkagg agg_num [-agg_num2]}
Syntax Definitions
ipmvlan-id Specifies the IP Multicast VLAN number to which the port will be
attached as a receiver port. The valid range is 2–4094.
slot/port The slot number for the module and physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
port2 Last port number in a range of ports you want to configure on the same
slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
agg_num The link aggregate ID number to be assigned as a receiver port to the
specified IPMVLAN. The valid range is 0–31.
agg_num2 Last link aggregate ID number in a range of aggregates you want to
configure.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• Use the no form of this command to remove the port assigned as a receiver port for the IPMVLAN.
• A single port can be configured as a receiver port for multiple IPMVLANs. An IPMVLAN can contain
multiple receiver ports.
• In the Enterprise mode, the configuration fails if the port configured as a receiver port is an aggregated
port (member port of a logical aggregate) or a VLAN Stacking port.
• In the VLAN Stacking mode, the configuration fails if the port configured as a receiver port is not a
VLAN Stacking port (user port).
Examples
The following commands configure the receiver port in the Enterprise mode:
-> vlan ipmvlan 1003 receiver-port port 1/51-60
-> vlan ipmvlan 1033 receiver-port port 1/62
To Next Page
Loading...
