Ethernet Port Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 20-17
interfaces ifg
Configures the inter-frame gap on Gigabit Ethernet interfaces.
interfaces slot[/port[-port2]] ifg bytes
Syntax Definitions
slot Slot number you want to configure.
port Port number of the interface you want to configure.
port2 Last port number in a range of ports you want to configure.
bytes Inter-frame gap value, in bytes. Valid range is 9–12.
Defaults
Platforms Supported
OmniSwitch 6250
Usage Guidelines
You can only configure one slot at a time. Repeat the command to configure additional slots.
Examples
-> interfaces 3/1 ifg 10
-> interfaces 3 ifg 10
-> interfaces 3/1-4 ifg 10
Release History
Release 6.6.1; command was introduced.
Related Commands
MIB Objects
esmConfTable
esmPortCfgIfg
parameter default
bytes 12
show interfaces ifg Displays the inter-frame gap value for one or more ports.
To Next Page
Loading...
