Chassis Management and Monitoring Commands
page 2-24 OmniSwitch 6250 CLI Reference Guide November 2009
stack set slot
Sets the saved slot number for a switch in a stacked configuration. The saved slot number is the slot posi-
tion the switch will assume following a reboot. The stack set slot command also provides syntax for
immediately rebooting the corresponding switch.
stack set slot slot-number saved-slot saved-slot-number [reload]
Syntax Definitions
slot-number The current slot position used by the switch (1–8; 1001–1008). Note that
the valid slot number range also includes slot positions 1001 through
1008, reserved for switches in pass-through mode.
saved-slot-number The new (i.e., saved) slot number (1–8). The saved slot number is the
slot position the switch will assume following a reboot.
reload Optional command syntax. When reload is entered in the command
line, a confirmation prompt is issued. If the user approves the reload, the
corresponding switch will be rebooted immediately and the new
(i.e., saved) slot number will take effect when the switch comes back
up—barring any pass-though mode conditions, such as duplicate slot
numbers.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• When the stack set slot command is issued, the new saved slot value is written to the boot.slot.cfg file.
This file is located in the switch’s /flash directory and is used when assigning a slot number for the
switch during the boot process.
• In order to avoid duplicate slot numbers within the virtual chassis—which can force one or more
switches into pass-though mode—be sure that the saved slot number being configured is not already
being used by another switch in the stack. To view the saved slot numbers currently assigned, use the
show stack topology command. For detailed information on assigning saved slot numbers, as well as
information on pass-through mode, refer to the OmniSwitch 6250 Series Hardware Users Guide.
Examples
-> stack set slot 2 saved-slot 3
-> stack set slot 1001 saved-slot 4 reload
Release History
Release 6.6.1; command was introduced.
To Next Page
Loading...
