Alcatel-Lucent OmniSwitch 6250 - 802.1 X Policy Default

802.1X Commands
page 44-16 OmniSwitch 6250 CLI Reference Guide November 2009
802.1x policy default
Resets the device classification policy to the default value for the 802.1x port.
802.1x slot/port {supplicant | non-supplicant} policy default
Syntax Definitions
slot/port The slot and port number of the 802.1x port.
supplicant Reset the supplicant policy to the default policy value.
non-supplicant Reset the non-supplicant policy to the default policy value.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
• The default non-supplicant policy blocks all non-supplicants from accessing the 802.1x port.
• The default supplicant policy blocks supplicants that fail authentication. If authentication is successful
but does not return a VLAN ID, then Group Mobility rules are examined. If no rules exist or match
supplicant traffic, then the supplicant is assigned to the default VLAN for the 802.1x port.
Examples
-> 802.1x 3/1 supplicant policy default
-> 802.1x 4/1 non-supplicant policy default
Release History
Release 6.6.1; command was introduced.