Port Mapping Commands
page 28-10 OmniSwitch 6250 CLI Reference Guide November 2009
show port mapping
Displays the configuration of one or more port mapping sessions.
show port mapping [port_mapping_sessionid]
Syntax Definitions
port_mapping_sessionid The port mapping session ID. Valid range is 1 to 8.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
If you do not specify the port mapping session ID, then the configuration for all the port mapping sessions
will be displayed.
Examples
-> show port mapping 3
SessionID USR-PORT NETWORK-PORT
-----------+----------------+------------------
8 1/2 1/3
8 1/6
8 1/7
Release History
Release 6.6.1; command was introduced.
output definitions
SessionID Displays the port mapping session ID.
USR-PORT Displays the set of user ports of a port mapping session.
NETWORK-PORT Displays the set of network ports of a port mapping session.
To Next Page
Loading...
