IPv6 Commands
OmniSwitch 6250 CLI Reference Guide November 2009 page 30-13
ipv6 neighbor
Configures a static entry in IPv6 Neighbor Table.
ipv6 neighbor ipv6_address hardware_address {if_name} slot/port
no ipv6 neighbor ipv6_address {if_name}
Syntax Definitions
ipv6_address IPv6 address that corresponds to the hardware address.
hardware_address MAC address in hex format (e.g., 00:00:39:59:F1:0C).
if_name Name assigned to the interface on which the neighbor resides.
slot/port Slot/port used to reach the neighbor.
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
Use the no form of this command to remove an entry from IPv6 Neighbor Table.
Examples
-> ipv6 neighbor 4132:86::203 00:d0:c0:86:12:07 Test 1/1
Release History
Release 6.6.1; command was introduced.
Related Commands
show ipv6 neighbors Displays IPv6 Neighbor Table.
show ipv6 information Displays IPv6 information.
To Next Page
Loading...
